The lubricating oil filling machine controls the target amount of the cylinder through the servo motor, and the operation is controlled by the solenoid valve and the motor. The solenoid valve uses the proportional solenoid valve and uses the output electromagnetic force of the proportional electromagnet to make the flow pressure and flow continuously and proportionally track the control signal, and change with the signal.
020-34563445The operation of the liquid Filling machine is controlled by the solenoid valve and the motor, the solenoid valve uses the proportional solenoid valve, and the output electromagnetic force of the proportional electromagnet is used to make the flow pressure and flow continuously and proportionally track the control signal, and change with the signal. When the motor rotates, it will drive the belt to rotate. When the filled barrels move on the belt through the photoelectric module, the number of barrels and the liquid level in the barrel will be detected and the data will be sent to the PLC module to complete the data collection and processing of the liquid level and the number of barrels, and the barrel flow speed and actual liquid level will be obtained. Then the obtained data and the original stored data or standard data are compared, if the filling speed is unchanged, the bucket flow speed must be consistent with the filling speed, the liquid level must also reach the standard liquid level, according to these judgments whether to adjust, so as to complete the monitoring of the filling.
The weighing filling machine sets the switch to automatic operation mode, when the switch starts, the conveyor drive motor will start and will remain until the switch stops. When the weighing module detects an empty barrel, the conveyor belt stops running; When the bucket is filled with liquid, the conveyor drive motor will automatically start, and when the weighing module detects the next empty bucket, the conveyor belt will stop moving again, so the continuous cycle; If the barrel is positioned under the filling equipment under the detection of the weighing module, stop for 1 second first, and then start filling, the filling time is set to 5 seconds, and there is an alarm display during the filling process to indicate that it is filling; After 5 seconds, the filling stops, and the alarm is no longer displayed; The alarm is triggered by flashing red lights at 0.5 second intervals. At the same time, record the number of barrels filled and the number of boxes with the specified number of barrels as a box of product. During the entire program operation, the current value of the counter that records the full box will be transferred to other registers at the specified time, and then the weighing filling machine will automatically clear to zero, so that the weighing filling machine can re-count.
